57 lines
1.6 KiB
Plaintext
57 lines
1.6 KiB
Plaintext
|
|
App for Motion Activated Light
|
|
==============================
|
|
==============================
|
|
|
|
This app listens for VALUE_REPORT messages on the bus. If a preselected value from a preselected node
|
|
is received (with a value !=0) the LED stripe attached to the node which runs this app will be turned on in
|
|
the preselected color for a preselected time. If in this time another matching message is received the
|
|
light timer gets restarted. If no matching message is received within the preselected time the light is
|
|
turned off again.
|
|
|
|
Typical usage is to watch for a motion message from some node with a motion sensor and react to that.
|
|
This app can watch for up to two node-value pairs.
|
|
|
|
|
|
|
|
1. Values
|
|
======
|
|
|
|
1.1 MALRGBWVALUE
|
|
----------------
|
|
|
|
RGB Value for activated light:
|
|
aqhome-tool setValue -N nodes/XXXXXXXX/MALRGBWVALUE -v GRWB
|
|
|
|
Example:
|
|
Set color of LED strip to blue (half intensity)
|
|
aqhome-tool setValue -N nodes/12345678/MALRGBWVALUE -v 0x80
|
|
|
|
|
|
1.2 MALONTIME
|
|
-------------
|
|
On-Time after activation:
|
|
aqhome-tool setValue -N nodes/XXXXXXXX/MALONTIME TIME_IN_1/10_SECS
|
|
|
|
Example:
|
|
Keep light on after activation for 20 seconds
|
|
aqhome-tool setValue -N nodes/12345678/MALONTIME -v 200
|
|
|
|
|
|
1.3. MALSOURCE1, MALSOURCE2
|
|
---------------------------
|
|
|
|
Sources for Motion Messages:
|
|
aqhome-tool setValue -N nodes/XXXXXXXX/MALSOURCE1 -v VVNN
|
|
aqhome-tool setValue -N nodes/XXXXXXXX/MALSOURCE2 -v VVNN
|
|
|
|
VVNN is a 16-bit value, lower 8 bit contain the source node address, higher 8 bit contain the
|
|
value id to react to.
|
|
|
|
Example:
|
|
React to value report messages with value id 7 from node with address 2
|
|
aqhome-tool setValue -N nodes/12345678/MALSOURCE1 -v 0x0702
|
|
|
|
|
|
|