
App for Motion Activated Light
==============================
==============================

This app listens for VALUE_REPORT messages on the bus. If a preselected value from a preselected node
is received (with a value !=0) the LED stripe attached to the node which runs this app will be turned on in
the preselected color for a preselected time. If in this time another matching message is received the
light timer gets restarted. If no matching message is received within the preselected time the light is
turned off again.

Typical usage is to watch for a motion message from some node with a motion sensor and react to that.
This app can watch for up to two node-value pairs.



1. Values
======

1.1 MALRGBWVALUE
----------------

RGB Value for activated light:
 aqhome-tool setdata -N nodes/XXXXXXXX/MALRGBWVALUE -v GRWB

Example:
  Set color of LED strip to blue (half intensity)
  aqhome-tool setdata -N nodes/12345678/MALRGBWVALUE -v 0x80


1.2 MALONTIME
-------------
On-Time after activation:
 aqhome-tool setdata -N nodes/XXXXXXXX/MALONTIME TIME_IN_1/10_SECS

Example:
 Keep light on after activation for 20 seconds
 aqhome-tool setdata -N nodes/12345678/MALONTIME -v 200


1.3. MALSOURCE1, MALSOURCE2
---------------------------

Sources for Motion Messages:
 aqhome-tool setdata -N nodes/XXXXXXXX/MALSOURCE1 -v VVNN
 aqhome-tool setdata -N nodes/XXXXXXXX/MALSOURCE2 -v VVNN

 VVNN is a 16-bit value, lower 8 bit contain the source node address, higher 8 bit contain the
 value id to react to.
 
Example:
 React to value report messages with value id 7 from node with address 2
 aqhome-tool setdata -N nodes/12345678/MALSOURCE1 -v 0x0702



